Cloud & Management - Tenant

top of page

Kiwire 3.0 Administrator - Device & Controller Setup Guide

Kiwire 3.0 Administrator - Device & Controller Setup Guide

Cambium Networks Configuration for Kiwire Hotspot

Cambium Networks Configuration for Kiwire Hotspot

Prerequisites

Before integrating the controller with Kiwire, it is necessary that the controller and access point:

are connected to the Internet
are reachable on the network
have an IP address assigned to the a through DHCP or static

Note:

Kiwire-hostname or Kiwire-ip can be obtain by contacting our technical support for our cloud customer. For enterprise client the ip will be on premises Kiwire ip address.
Social network hostname list can be obtained from Social network whitelist guide

Part 1: Cambium cnMaestro configuration

Login to your Cambium cnMaestro controller

Go to WLANs > Configuration > AAA Servers
1. Authentication Server
  1. Host: Kiwire-hostname or Kiwire-Ip
  2. Secret: create a secret pass phrase
  3. Port: 1812
  4. Timeout: 3 seconds
  5. Attempts: 1
2. Accounting Server
  1. Host: Kiwire-hostname or Kiwire-ip
  2. Secret: secret same as authentication server
  3. Port: 1813
  4. Timeout: 3 seconds
  5. Attempts: 1
  6. Accounting Mode: Start-Interim-Stop
  7. Accounting Packet: ticked
  8. Interim Update Interval: 1800 seconds
3. Advanced Settings
  1. NAS-Identifier: AP MAC address with capital letters and colon
  2. Dynamic Authorization: ticked
  3. Dynamic VLAN: ticked
  4. Called Station ID: AP-MAC:SSID

Omaya 3.0 Administrator > Quick Setup > Dashboard

Documentation

Omaya 3.0 Administrator > Cloud & Management > Tenant

Articles in this section

Device & Configuration

Master Data & System Setting

Cloud & Management

Omaya 3.0 Administrator - Cloud & Management

Tenant

This module allow you to configure and manage cloud tenant.

bottom of page