Kiwire 3.0 Administrator - Device & Controller Setup Guide
Kiwire 3.0 Administrator - Device & Controller Setup Guide
Cambium Networks Configuration for Kiwire Hotspot
Cambium Networks Configuration for Kiwire Hotspot
Prerequisites
Before integrating the controller with Kiwire, it is necessary that the controller and access point:
-
are connected to the Internet
-
are reachable on the network
-
have an IP address assigned to the a through DHCP or static
Note:
-
Kiwire-hostname or Kiwire-ip can be obtain by contacting our technical support for our cloud customer. For enterprise client the ip will be on premises Kiwire ip address.
-
Social network hostname list can be obtained from Social network whitelist guide
Part 1: Cambium cnMaestro configuration
-
Login to your Cambium cnMaestro controller
-
Go to WLANs > Configuration > AAA Servers
-
Authentication Server
-
Host: Kiwire-hostname or Kiwire-Ip
-
Secret: create a secret pass phrase
-
Port: 1812
-
Timeout: 3 seconds
-
Attempts: 1
-
-
Accounting Server
-
Host: Kiwire-hostname or Kiwire-ip
-
Secret: secret same as authentication server
-
Port: 1813
-
Timeout: 3 seconds
-
Attempts: 1
-
Accounting Mode: Start-Interim-Stop
-
Accounting Packet: ticked
-
Interim Update Interval: 1800 seconds
-
-
Advanced Settings
-
NAS-Identifier: AP MAC address with capital letters and colon
-
Dynamic Authorization: ticked
-
Dynamic VLAN: ticked
-
Called Station ID: AP-MAC:SSID
-
-
Omaya 3.0 Administrator > Quick Setup > Dashboard
Documentation
Ubiquiti Networks Documentation > airFiber
Ubiquiti Networks Documentation - airFiber
Getting Started
airFiber – How to Export and Delete Device Data
airFiber – FAQ Getting Started
airFiber – Which product should I use?
airFiber – How to Align an airFiber Antenna
airFiber – Updating the Firmware
airFiber – Output Power Needed to Achieve Desired Modulation
airFiber – What is the Maximum EIRP in the United States?
airFiber – How to use Ethernet Carrier Drop in airOS F v4.X
airFiber – airFiber5X vs Rocket 5AC
airFiber – Understanding Half/Full Duplex
airFiber – Choosing a Surge Suppressor and Lightning Arrestor
Design & Planning
airFiber – How to Ground an airFiber Properly
airFiber – Device Models and Duplex Modes
airFiber – What antennas can be used with the AF-4X?
airFiber – Design and Deployment for the airFiber NxN System?
airFiber – AF24 Topology Options
airFiber – Co-locating Radios in the Same Site
Troubleshooting
airFiber – Troubleshooting and Requesting Support
airFiber – Troubleshooting Signal and Link Issues
airFiber – Troubleshooting an Inaccessible Device
airFiber – Troubleshooting Good Signal but Bad Data Rates
airFiber – Ethernet Negotiation Issues
airFiber – How to Reset with TFTP Firmware Recovery